Colorunion printing cartridge, Make your life more colorful

Hp88a drums plus powder graphic _88a drum unit and powder graphic _hp88a drums plus powder - Shenzhen drum manufacturers

by:Colorunion     2020-09-06
In order to thank you to our customers have been great support, today I come in the form of pictures for you to explain in detail the whole process of hp88a drums plus powder, detailed steps are as follows:
1. First remove the hp88a drums from the printer, and ready to use carbon powder, as shown in the figure below:

2. Remove the drum gear on the screws, and remove the side cover, 1 side cover note don't get lost in spring, as shown in the figure below:


3. Remove the side cover 2 screws and remove the side cover, as shown in the figure below:


4. In the direction of the arrow gently pull separate powder storehouse and waste powder storehouse, then gently turn the drum core and remove the drum core, as shown in the figure below:


5. Remove the charging roller and clean, and then remove the screws at the ends of the scraper, as shown in the figure below:


6. Remove the scraper and clean, and then clean up the waste powder, finally according to the in-situ installation scraper, charging roller, drum core, as shown in the following:

7. Remove the gearless side of the drum unit half side cover screws, then remove the magnetic roller clean, as shown in the figure below:


8. To crack under the magnetic roller mouth add carbon powder, add after the Ann is put back all the parts again, as shown in the figure below:


9. Put back all the accessories, after such hp88a drums plus powder, the whole process and finished it.
Custom message
Chat Online 编辑模式下无法使用
Chat Online inputting...